October 20, 2014
Trying to source a few small bits
Trying to source a few small bits
Does anyone know where I could source the following?
I have two of these THK rod ends on a gear shift rod and I’ve split the rubbers that were holding some grease around them. (Could probably do with replacing one as it’s a bit rusty). My local engineering crown have the rod end but no rubber boot. Anyone know where I could get both or just the rubber boots?
Also I’m looking for an exhaust can mount bush for a zx10r. It’s the mount that goes inside the pillion footpeg. Might try some breakers but if anyone knows what else might do the job? I could probably make something rough myself….I’ts O.D. 19mm and the I.D. of the sleeve doesn’t really matter I suppose as long as I can get a bolt to fit it.