Hi All,

I’m after changing the spark plugs on my FZ600n as lately it didn’t want to rev past 11k and seemed slightly sluggish. I have now changed all 4 plugs but cannot get it to start. It will turn over fine and I am getting a spark but the plugs felt bone dry when I took them out after turning it over a few times so I’m guessing I’m not getting fuel.

To change the plugs I removed the tank (I left all hoses and wires connected and just swung it around and left it sitting on the seat).

I then removed the sensor to the airbox along with the 4 hoses & loosed the rubber boots going to the throttle bodies and removed the airbox.

I then removed the two electrical connectors on top of the battery and unbolted the two terminals & removed the battery.

Next I removed the coilpacks.

I then had access to the plugs and swapped them out for new ones and put it all back together which is as far as I’ve got.. As I said it will turn over but will not start (Yes I have fuel in the tank).

I’m not sure on what to do next and I’m in a bit of a panic to get this bike back on the road as it’s my only way to get to and from work.

Any suggestions would be greatly appreciated lads!!